I set the Z and clicked on cycle start and the Z lifted to 5.8 and as the M03 command activated the spindle board relay, the computer lights on the front panel flickered and everything went dead. Then I decided to do a test run with g-code (Part of the program Listed below) everything was going well, I jogged the machine using keyboard arrow keys and was quite impressed with the difference it made. I connected the UC100 Motion controller and installed the software. I decided to add a UC100 USB motion controller to improve the performance. I have a 490mm X 490mm machine running on Mach3 via LPT1 (Windows XP) which works perfectly except for the normal problems related to parallel port.
I am currently faced with a problem and can't seem to find an answer and therefore I registered on CNCZone to ask the question. Over the last 3 years I have always found answers to questions that I had on this forum. First of all I would like to thank everyone on this forum for their questions and answers which I have found very informative.
0 kommentar(er)
